Forget WiFi

How to Forget the WiFi

You’ve setup the WiFi but then you switched to the Cable.

Your miner is showing 2 ip addresses so you only want to use the Ethernet not WiFi.

Here’s the steps to forget the WiFi using Helium Hotspot Utility App. Connect your Miner via Bluetooth, scan it and connect to the hotspot. Then follow steps below:

  • Connect
  • Config
  • Choose current Wifi
  • Clear password and Click Connect
  • App shows Failed
  • Back to hotspots and run a Diagnostic report
  • WiFi forgot
How to Connect to WiFi
1. To use WiFi (optional), Download Hotspot Utility App

2. Enable bobcatminer Pair Mode
Use the Pin to push BT button for 5 seconds until the light turns BLUE. If it doesn’t turn blue, wait for a while (minutes) then try again. If you’ve paired once and it turned to GREEN or YELLOW, restart the Hotspot and try again.

4. Configure Wi-Fi

Just follow the Instruction in the App

  • Scan
  • Connect
  • Configure

Need to Forget the Wifi?

Buy Bobcat Miner from the official website: https://www.bobcatminer.com.

Order NOW

Leave a Reply

Your email address will not be published. Required fields are marked *